what parameters are should nessary for control technic dc
drive(in rolling mills)?
No Answer is Posted For this Question
Be the First to Post Answer
What is the necessary condition for stability.
sir plz send some previous year questions of jspl.
what is the Transformer Impedence?How can calculate?
How to calculate amount of copper used in a motor (AC&DC), generator and transformer? Datasheet provides power rating and mass of the equipment....can we somehow use this available info.
There are 2 Flip_Flop with logic between them. Given Clock to Q delay, logic prop. delay, set up and hold times specify maximum clock frequency of system. What happens if second output fed back to first input. Any changes? What happens with timing if second output is fed back to logic between the flops? Good Luck!
i am getting to neutral earth voltage zero ,is this a perfect earthing ?
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
What are the protections required in the main lt panel which is connected to the transformer.
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
WHY WE NEED AUTO TRANSFORMER,WHERE WE CAN USE?
Why the wave trap is put in Y phse only in switchyard?why not in other phases?
1 Answers IAG Automation, REL,
Is there any problem ,if R-Y-B voltage is constant , but the air compressor taking one phase high current.what is possible causes.the said compressor is very new.(55kw).