What is the rating of your substation and what are the
different types of substations?
Answer Posted / tarun aggarwak ymca
765kV, 400kV,220kV,132kV , 66kV,33kV,11kV
The substations can be classified in several ways including the
following:
i) Classification based on voltage levels e.g.:
AC Substation: EHV, HV, MV), LV;
HVDC substation
ii) Classification-outdoor or indoor.
Outdoor substation is under open sky. Indoor substation is
inside a building.
iii) Classification based on configuration, e.g.:
a) Conventional air insulated outdoor substation or
b) SF6 Gas Insulated Substation (GIS)
c) Composite substations having combination of the above two.
iv) Classification based on application.
a) Distribution substation
b) Switchyard in Generating Station
c) Switching substation (without power transformers)
d) Sending-end substation
e) Receiving substation
f) Factory substation
g) Compensating substation e.g. having static var compensation etc.
h) Load substation, e.g. arc-furnace substation.
| Is This Answer Correct ? | 25 Yes | 6 No |
Post New Answer View All Answers
before synchronizing an alternator,power factor is leading ,why?
Why in power plant projects we see DOL starting method used for motors upto 160 kW instead of star delta method
Tell me in detail about c.t. And p.t. ?
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
What is the breaking capacity of transformer and how can we calculate the breaking capacity of tranformer
working principle of AC Servo Motor with its construction
what is meant by LCR meter? where its useful ?
Is it possible to measure the voltage of a battery from a single terminal?
what happen as when voltage drop(or may decrease) ? in case of atomic base theory?
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
What is the maximum percentage voltage drop (vd%)for a motor control center
working principle a.v.r. ?
what are the condition that makes hooter blow?
Alternator rotor earth fault relay circuit
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?