Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / uday
Span is a algebraic difference between the limits of the range from zero to full scale.
The range is that difference in minimum and maximum operating parameters that the instrument will withstand without damage.
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What is the difference between PLC and DDC?
What are advantages and disadvantage of the ac supply load cell?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
Tell about your IFFCO plant visit.
where proximity sensor installed on tank in loading arm application
where cascade loop use ?
wich is coming the first HAZOP OR SIL
What is three element drum level control system why its better than single element?
how to work MIL contol valve posistioner ?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
What is the diffrence between ff tx and non ff tx
How servomotor controls throttle valve of TURBINE?
