Am using an electronic digital display to see the RPM of ABB ACS 550 drive, whic

Am using an electronic digital display to see the RPM of ABB ACS 550 drive, which is showing negative value when the motor & drive in stop mode but it is showing correct value during the run mode. can anyone help me out??

Question Posted / chanti

2 Answers
3350 Views
Bala Power Solutions, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Am using an electronic digital display to see the RPM of ABB ACS 550 drive, which is showing negativ..

Answer / cae

Thank you Chandra padhi, but cud u please tell me how to do that in briefly. Am very thankful to u if u help me

Is This Answer Correct ?

1 Yes

0 No

Am using an electronic digital display to see the RPM of ABB ACS 550 drive, which is showing negativ..

Answer / gobinda chandra padhi

I think Zero adjustment required and check the range of the controller.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Why a dc generator gives result during two different condition,- 1)separately exited gen.- Eg=110 V, field current=0.25 A. 2) self exited gen.- Eg=30 V, field current=0.025 A.

1 Answers

how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids

0 Answers

the max. power will be transferred if …… a) sending end vol. is high b) receiving end v is high c)…….. d) corona loss is least

2 Answers Engineers India Limited,

What will be the output of an alternator ,if the field current is single phase ac supply.

1 Answers DRDO,

purpose of flux relay for turbo generator in power plant

1 Answers

can we step up dc power using transformer?

15 Answers

why the carbon brushes are used heat created rotating parts in eiectricity

1 Answers

Differentiate between power relay and reverse power relay?

2 Answers ABB, TVS,

WHEN THESE TRANSFORMERS WINDINS CONFIGURATION ARE USED? SPECIALLY EXPLAIN REGARDING STEP UP AND STEP DOWN KEEPING IN MIND.AND REGARDING LOAD ALSO. a.star to delta b.delta to star c.delta to delta d.star to star ALSO EXPLAIN WHY V USE 415/415 TRANSFORMERS IN TUBEWELLS?

1 Answers ABB,

How to measure size of cable on a given load

0 Answers Green India Engineering Solutions,

what is the right method of laying cable tray if we are using EOT crane in shed, better is below or up

1 Answers

how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size

0 Answers Tyco,

For more Electrical Engineering Interview Questions Click Here