Interested to Buy Any Domain ? << Click Here >> for more details...
Am using an electronic digital display to see the RPM of ABB ACS 550 drive, which is showing negative value when the motor & drive in stop mode but it is showing correct value during the run mode. can anyone help me out??
- 2 Answers
- 3575 Views
- Bala Power Solutions, I also Faced
- E-Mail Answers
Answer Posted / gobinda chandra padhi
I think Zero adjustment required and check the range of the controller.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How are load losses and no-load losses measured at site in a DG set?
what about the power of wattmeter at starting and loding?
what is dc mator?types of dc motor?losses in dc motor?what is the mechanical,electrical and commercial efficiency of a dc motor?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
block diagram of 2 ups system connected in parallel mode?
what do u understand about FACTS? how they are useful?
What is the formula to calculate the no load current of a single & three phase induction motor
working principle a.v.r. ?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
What is transformation ratio what it describes?
List examples of voltage source?
Is it possible to measure the voltage of a battery from a single terminal?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
one electromagnet is called
what is diff. between earthing grid,earthing mess, earting grid?
