Answer / kumaran

The K factor is the design of Flow sensor. That needs to be key in to the flow transmitter. The K factor tell the relation between the flow transmitter and the sensor. if the K factor value is wrong, the flow values are not stable.

what r the different types of instrumentation cables? give their specification?

3 Answers  

---

if we put any thermocouple on a table in a room without any connection,what temperature should it show.

3 Answers  

---

why level transmitter input is given 4to20ma

2 Answers   Sabic,

---

how to control motor load with rpm or vfd

1 Answers  

---

What is loop or pigtail in an impulse line?

8 Answers   Qatar Airlines, Qatar Petroleums,

---

I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.

0 Answers  

---

What is diffrence between Transducer and Transmitter?

13 Answers   Ford,

---

If mVolts can drop by resistance of wire as compare to mA, then how thermocouple mV reaches in CCR as accurate value?

7 Answers  

---

how to solve temperature error in compressor?

1 Answers  

---

modbus and profibus communication difference?

1 Answers  

---

what is intrinscily safe system and where we use?

0 Answers   DEWA,

---

what is difference between two wire &three wire pt 100 ?

3 Answers   Jindal,

---