why k factor is important to know in flow transmitter. if we don,t know k factor what will be issue we can face .
- 1 Answers
- 2899 Views
- Flour Tech Engineers (P) Ltd, I also Faced
- E-Mail Answers
Answer Posted / kumaran
The K factor is the design of Flow sensor. That needs to be key in to the flow transmitter. The K factor tell the relation between the flow transmitter and the sensor. if the K factor value is wrong, the flow values are not stable.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
what is function of switch, and how is it work, explain with difination
what is piezoelectric transducer?give an example in power plant n state its principle?
What is the difference between uv and ir scanners? and what is the workig principle of both
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
Explain the working of rota meter.
why I need valve guard and whats different between guard and positioner ??
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
Explain plc level and its type?
why fuse block is not used for AI signal?
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
How we calculate orifice plat size???
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
