how to convert udl into point load??
Answer / asif
by multiplying the uld with total span of the beam i.e for example udl is 2 kip/ ft & beam span is 30ft .then 2*30 =60 kips & it will act at centre i.e 15ft from both of the supports
Is This Answer Correct ? | 35 Yes | 3 No |
reinforcement slab, beam and column formulas?
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
Explain what is the release of lien?
Sir please Bhel Enigineer trainy test papaers in civil engineering
At which place Construction joint should provide in slab and Beam at the time of casting.
rate analysis hiring of generator 62.5 KVA
The foundations are placed below ground level, to increase?
yasser arfatcompleted his degree in civil from which university
What is language of Engineering?
12 mm dia not available at site for raft, 10 mm are available at site how to calculate?
What is the different type of slump test indications?
What is the Compressive strength of concrete C40/20 at 7days