Specify the crystal frequency required for an 8085 system to operate at 1.1MHz
Answer / subhashis kar
The crystal frequency in an 8085 system is twice the desired clock frequency, so the crystal frequency required for an 8085 system to operate at 1.1 MHz clock frequency is
= 2*( clock frequency)
= 2.2 MHz.
Is This Answer Correct ? | 27 Yes | 2 No |
CAN A CD/CLOCK RADIO WITH 110V 60HZ WORK ON A 110V 50HZ FEED.
there are cam operated switches - why we call cam operated , What is cam ?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
a 120 60 watt incandescent lamp has to be operated from 50 c/sec 1 phase ac supply. in order to do this a circuit element has to be connect in series with the lamp. which one of the following sries element is preferable.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
two bulbs of 100w and 40w respectively connected in paralel across a 230v supply.which bulb will glow bright and why?
WHAT CAUSED THRESHOLD VOLTAGE TO EXIST?
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
Why the efficiency of generator is more than motor in swinburne's test
why we r used APFC Panel in industrial area.when P.F. low then wat will be the effect in our system?
10 Answers ABB, Georgio Rocks, Piramal Healthcare, Zenith Engineering Corporation,
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
what is advantage of using star to delta in place of dol starter