Answer Posted / subhashis kar

The crystal frequency in an 8085 system is twice the desired clock frequency, so the crystal frequency required for an 8085 system to operate at 1.1 MHz clock frequency is
= 2*( clock frequency)
= 2.2 MHz.

TO CALCULATE THE RESISTANCE OF GRR OF HT MOTOR 400KW WHEREAS STATOR VOLTAGE 6.6KV AND ROTOR VOLTAGE 705V AND ROTOR CURRENT IS 346A.

5566

---

which model T or pie model is prefarable in power syatem

1935

---

IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?

1952

---

What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?

2240

---

What is frantic effect?

1329

---

how to calculate maximum current

2384

---

How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend

2119

---

Use of switch mode power converter in real-time basis?

1226

---

State ohm’s law?

1168

---

In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?

1742

---

What does the term “voltage regulation” means?

1175

---

Define steady state error.

1143

---

how braking & making capacity of circuit breaker are calculated?

2354

---

What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw

1951

---

please forward me the type of questions which would rise while me attending to 33KV Electrical License to my mail ID:vadrevu_raghava@yahoo.co.in

2069

---