why we short ckt the secondry vo5tage/
winding in transfr and motor?

Answers were Sorted based on User's Feedback



why we short ckt the secondry vo5tage/ winding in transfr and motor?..

Answer / damodarreddy

in case of motor the secondary winding is rotor.if there is
no short circuit in rotor,rotor winding is not a closed
circuit i.e open circuit.in open circuit voltage wil develop
but there is no current flows in the rotor winding it causes
the rotor doesnt rotate.
according to faradays laws of electro magnetic induction
when ever a current carrying conductor is placed in a
magnetic field the conductor will try to rotate.
if there is no short ckt,no cuurrent in winding and then how
to rotate.hence secondary (or) rotor of a motor is short
circuited.
in my point of view

Is This Answer Correct ?    5 Yes 0 No

why we short ckt the secondry vo5tage/ winding in transfr and motor?..

Answer / k.prakashchandra

I think it the lower voltage winding which is shorted, not
compulsorily the secondary.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

what is an alternator & generator

5 Answers  


WHAT IS THE FULL FORM OF ONAN ( TYPE OF COLLING IN TRANSFORMER)

7 Answers  


What happen to alternator if prime mover fails?

4 Answers  


how to design the heater in temperature control unit to heat 50KL of water?

0 Answers   SunMax,


How can we have to decided motor connection as a STAR-DELTA or DELTA-STAR?

3 Answers   IOCL, Jindal,






what is the radio of kva & kvar or why calculated kva & kvar

3 Answers  


Advantage of LT panel vs HT panel

0 Answers  


Meaning of CTPT ,how it works &how it measures the reading on trivecter meter,&what is trivecter meter

1 Answers   PF, Student, TSSPDCL,


what is the full Form of AAC ant conductor?

5 Answers  


Instead of single phase(220), if we apply Phase to phase (R&Y)supply (eg: for lighting fixture). what will be the power formula?

1 Answers  


IN 3 PHASE INDUCTION MOTORS SOMETIMES COPPER BARS ARE PLACED DEEP IN ROTOR WHY..?

3 Answers   ONGC,


HOW GENERATING END VOLTAGE LEVEL (6.6 KV/ 10.5 KV/ 11 KV/ 13.5 KV) DECIDED IN POWER PLANT. ON WHAT FACTORS THE GENERATING END VOLTAGE DECIDED, & WHAT IS THE CALCULATION USED FOR THIS.

3 Answers   Areva, Cognizant,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)