Answer / s b mutha

Voltage Ratio : 11000/440= 25, 33000/440= 75
So, current in primary will in 11KV= 4 Amps and in 33KV= 1.333 Amps

Answer / saraz06a0222

If KVA is known then these are the formulas

Current in LT side
=KVA *1000/1.732*LT VOLTAGE*COSQ


Current in HT side
= KVA *1000/1.732*HT VOLTAGE*COSQ

how do we calculate cable sq mm size,that if 50 A load

2 Answers   GTL, PowerTech,

---

One 200 V, 100 W bulb is connected in series with primary of a 200 V, 10 kVA transformer. If its secondary is kept open circuited, then the bulb would have (1) Full brightness (2) Poor brightness (3) A little less than full brightness (4) More than full brightness...explain

2 Answers  

---

what happen if we give square wave instead of sine wave to the transformer

8 Answers  

---

I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????

0 Answers  

---

HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com

0 Answers  

---

Why Neutral Isolation is required?

0 Answers  

---

what is self capacitance of inductor

0 Answers   Bhel,

---

Is it possible to use AC supply insted of DC supply in trip coil operation? if not, why?

5 Answers   HAL,

---

What do you mean by nominal ratio of instrument transformer?

1 Answers  

---

what is the purpose of taking HV test in LT panel.

1 Answers   PCE,

---

What the reson for frequant instantaneous ground over current fault in our sync. Generator... 15 triping in 24 hr...

1 Answers   HCPL, Jhunjhunwala Vanaspati Jhoola, Regen Powertech,

---

if field winding of synchronous generator are shorted on each other will it start or burn or run for short time like induction motor

1 Answers  

---