Voltage drop is the:(a) Maximum potential(b) Difference in potential between two points(c) Voltage at the end of a circuit(d) Voltage produced by a source
Answers were Sorted based on User's Feedback
Difference of voltage between the starting to the end point.
| Is This Answer Correct ? | 6 Yes | 1 No |
How can I known multiplying factor .without multiplying table
Why Ferranti effect is occoured in leading power factor load in a overhead transmission line?
explain me the exact concept of generator neutral....????
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
How can we prevent the (Home)inverter supply flow to the main supply line?
What is the instrument to check the rotating diode fuse of alternator in running conditions?
can we run the home fan both clock and anticlockwise direction
what are the standard transmision voltages in india?
An AC coil to give DC supply whats happen in the coil.what type of problem are create.
what is difference between neutral and ground wire?
Design and explain a circuit to produce an unregulated full wave D.C supply.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)