Voltage drop is the:(a) Maximum potential(b) Difference in potential between two points(c) Voltage at the end of a circuit(d) Voltage produced by a source
Answer Posted / dheeraj.yadav
Difference of voltage between the starting to the end point.
Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
As we know induction squirrel cage motor torque Directly praprortinal to applied voltage in star connection & delta also. If I connect 55KW Motor to DOL starter in load condition does motor withstand the load & what will be the current withdrawn ? motor will not fail ?
What is the difference between alternator and generator?
Iin ESP why positive is grounded ? why not negative ?
condition Autotrip facia come on control panel of electrical transmission line?
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
what are the steps involved in generator load test?
what is draiv work
Define step response?
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
what r the checklist while installing a 380 kva DG set
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
why we use 630mm single core cable for transformer secondary side and why two neutral cable