What is corkscrew rule?

0 Answers  

---

why multiplying factor is used in wattmeter???

1 Answers   Nippon,

---

What does CDG,CDAG,CAG,VAJ,VAJH,VTT,VAZ,VAA etc. stands for in case of relays and can anyone answer to decode this codes C,V,D,G,A,X,TT,J,JH etc

4 Answers   HNL,

---

The temperature rise in the sys, which leads to ….. a) Increases stress& length b) increases stress but decreases length c) Decreases stress & increase length d) decrease stress & length

1 Answers   Engineers India Limited,

---

What is meant by a linear circuit and what is a non- linear circuit?

5 Answers  

---

---

We have two Al.busbars each of size 125mm*10 mm connected in parallel.To increase the current rating ,can we connect third busbar of size 100mm*10mm in parallel to existing two busbars?In my opinion ,if we connect busbars of different sizes in parallel,then the busbar of lowest size will take much current.So this type of paralleling should be avoided .Am I correct?

1 Answers   PDP Steel,

---

At full load wat is the motor p.f And at no load will is the motor p.f?

0 Answers   GEPL,

---

what is difference between delta-delta,delta-star transformers ???

3 Answers  

---

A jet of fluid strikes a plate What was the force required to counter it?

0 Answers  

---

A current of 2A flows for 10 hour through a 100 ohm resistor. The energy consumed by the resistor is:(a) 0.5 kWh(b) 4 kWh(c) 2 kWh(d) 0.02 kWh

3 Answers  

---

-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.

0 Answers  

---

what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me

0 Answers   Escorts,

---