Answer / nitin.sonurlekar@gmail.cm

Orifice plate is a device used for measuring flow rate by  reducing pressure or for restricting flow or also used for creating Differential pressure.

OP types :
•    Concentric.
•    Segmental.
•    Eccentric.
•    Quadrant Edge.
 

Answer / faiyaz

1 .Concentric
2 .Eccentric
3. Segmental
4. Quadrant Edge

Q- Ordinary Water Tap is which kind of controller ? P , PI or PID i chose the option of ON - OFF type controller but ambiguity is that for different positioning of tap we get different flow

1 Answers  

---

As you are fresher in Instrumentation & control engineer.Then why should I select you?

1 Answers  

---

how we convert Mili ampere to temp txt,level txt,flow txt,pressure txt range value

4 Answers   Saadi Cement,

---

Which topics are covered in Process Control?

0 Answers   Honeywell, L&T,

---

WHY WE R NOT USING THE TURBINE FLOW METER IN THE STREAM SERVICE ? pl explain?

3 Answers  

---

What are the instrumental diagram of valve.

2 Answers   Karnataka Power,

---

If an Instrument has 550 ohm internal resistance and the cable used for that instrument is 0.5 ohm per meter resistance. If the voltage is 12volt.How much length cable can be used?

2 Answers  

---

wht is dcs architecture ? can u give example?

3 Answers  

---

Vibration probe working principle?

1 Answers   Tata Steel Limited,

---

I am working in a process industry, in that there are several sections devided in the SCADA screens and individual sections may START independently. But sometimes i am facing problem i.e, if section 2 Stopped by the operator immediately Section 1 or Section 3 or Section 4 is getting stopped can you expain the reason behind this?

5 Answers  

---

What is DCS?

4 Answers   GAIL, Sabic, Trident, Yokogawa,

---

If range of 3-15 psi, a multiplying relay with a 1:2 ratio would give what output pressure for 6 psi input?

1 Answers  

---