Answer / bhanu

first of all you have to match the generator voltage & frequency with grid then you can synchronise

Answer / npti.pe

1st match the voltage and freq of gen. and grid, then using a synchro-scope match the phase while closing the GCB

Answer / sarang

we have match our voltage freq. and phase angles with the grid values only then we synch,

voltage and frequency is equal but synchronisation not complete why?

1 Answers  

---

why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.

0 Answers  

---

What is reheater protection based on what mft will be act on RH protection

2 Answers  

---

what is the difference between kg/cm2 to MMWC

2 Answers   Ansaldo,

---

What are the motors used in a thermal power plant? (With type and ht/lt) What voltage levels are used in a thermal power plant?

2 Answers   OPG,

---

what is actual CAL MODE & cal means?

2 Answers   GIPCL,

---

Why attemperation is required in HRSG in a combined cycle power plant?

10 Answers   Tata Power,

---

dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job

0 Answers   dbpl,

---

Which will have more strain energy 1.Spring 2.Circular disc 3.Solid square plate.

0 Answers  

---

Due to the sensitive earth fault Our Power plant Get Tripped Several Times, It happens in the morning time daily, When temperature rises that means sun rises the earth fault current get lower, in this situation What should I do to get rid of this Problem?

2 Answers  

---

In a coal fired boiler furnace temp. is high but super heater out let temp. low what reason for this?

6 Answers   ABB, Essar, Gayatri,

---

How to decide Heating surface area of boiler on their steam generating capacity?

4 Answers  

---