When motor stater and roter air gap do big then what will moter.

Answers were Sorted based on User's Feedback



When motor stater and roter air gap do big then what will moter...

Answer / praveen kumar

Amp will high

Is This Answer Correct ?    5 Yes 0 No

When motor stater and roter air gap do big then what will moter...

Answer / asit

larger air gap is equal to higher reluctance so lower reactance  .so i=v/z(z=r+xl) so currnt will be high.thats why no load current in case of induction motor 20-30% of full load current as compare to transformer that is 2-5% of full load current 

Is This Answer Correct ?    1 Yes 0 No

When motor stater and roter air gap do big then what will moter...

Answer / rinkesh

Large air gap .....more reluctance. ....need more current

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

1ampear me kitna watts hota hai aur elcb ka pura naam kya hai

18 Answers   Al Khayyat, Alpha G, BEC, Bhel, CGS, Electrical, Fiem, Firmenich, HLG Habtoor Leighton Group, Jash, Kandia, Maruti Suzuki, Minda, NTPC, ONEIC, Pace Process Controls, SMTC, SR, Sunrise Electrical, Sushil Enterprises, Suzlon, Voltage,


why we use 20 KV, 10KA LA on 22 KV Line

2 Answers  


why not feeling shock while touching rotor shaft of induction motor during running condition? during running condition emf induced in rotor.

1 Answers  


can we use optical fibre to electrical power transmission ?

1 Answers  


What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?

0 Answers  






Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more

3 Answers  


In a 11KV 3phase system do you need to earth both sides of the cable?

2 Answers  


I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF

0 Answers  


if a 2 ohm resistor,2 ohm capacitor and a 2 ohm inductor is connected parallely to 12v source.Then what is the value of current in each branch.Is current flows in each branch at the same time?If not so then provide the proper sequence

1 Answers   Tata Steel Limited,


What is Grounding? any difference b\w earthing? if yes plz explan??

3 Answers   ABB,


what is difference between AC VVVF drive & Dc VVVF drive explain their working principle?

13 Answers   Apollo, OPS,


why r we using shell transformer for low voltage

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)