When motor stater and roter air gap do big then what will moter.
Answer Posted / praveen kumar
Amp will high
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
What are the two segments of nyquist contour.
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
how brushed dc motor operating ?
What is the formula to calculate the rating of a three phase air circuit breaker
Why power genaration in India is at 50HZ while America its 60HZ
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
how to find Harmonics and types as per the equipemnts
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
How to calculate the heat load for a electrical room
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
Why Stabilising Resistor used in REF circuit ?
Write down the design procedure of commutaj.
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?