Is there any specialised book to refer about fault level
calculation both in MV and LV side??
No Answer is Posted For this Question
Be the First to Post Answer
how i can calculate the size for fire cable
why the transformer secondary voltage is more than the load end voltage like t/f 11KV/433V for 415V(terminal voltage)
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
why three phase capacitor takes unbalanced current in capacitor bank?
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
when a 500kva-400hz single phase transformer operated on a 100hz supply then what will be kva required
What is the diff. between two phase & three phase supply.
Where the excitation is given either stator or rotor in actually in power plants?
what is DAR test?
2 Answers Al-Naboodah, ISRO, ONGC,
What is the field weakening mode of a ac motor?
In Ferranti effect,Receiving end voltage is greater than sending voltage,why? can anybody tell me the answer
15 Answers Engineers India Limited,
i asked a funny question in Electrical ohms law V=IR in const temp voltage is directly proportional to current Power p=VI cos@ in that formula Voltage is indirectly proportional to current Try to give me the fact what is happening in Electrical.. contact Thanigai_1984@yahoo.co.in
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)