Answer / naveen ankalagi

Impedance connected to the secondary of the ct

Answer / k.prakashchandra

As burden is expressed in VA ,take the above answer as voltage across ct secondary x current

What will be the output of an alternator ,if the field current is single phase ac supply.

1 Answers   DRDO,

---

when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....

0 Answers  

---

Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com

0 Answers  

---

WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?

0 Answers  

---

pls give proper discription of selection of transformer based on particular load.

1 Answers  

---

What are the factors to be considered during the Synchronization?

3 Answers  

---

what is high and low cut off voltage of BB and DG at SPS????????

0 Answers  

---

why neutral is required in electrical system

3 Answers   Bhel,

---

Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,

0 Answers  

---

If a 3 phase transformer is a 500 kva using the formulae 500kva= 500000/433 x 1.732 = 666.71amps does this mean that each phase on the secondary side is 666.71

3 Answers   Saffron,

---

what is difference between di electric and insulator?

2 Answers   Greenko,

---

How will you Physically differentiate A.C and D.C motor?

10 Answers   BSNL, Polycab,

---