Answer / 7anoter4

See:NESC National Safety Code clause 233.
See: http://www.rurdev.usda.gov/supportdocuments/uep_bulletin_1724e-200.pdf
Section 6

I am doing apprenticeship training at HT switch yard in NLC. How can i get electrical c license. ??? What r the rules for getting it as an apprentice? ??

0 Answers  

---

what is the different between HT auxillary relay resistance and transformer tripping relay resistance?

0 Answers  

---

what is the iron loss in a 11KV/440V transformer?

2 Answers   Bhel, TVS,

---

what are the disadvantages of leading P.F(power factor)?

2 Answers  

---

what are the electrical components required for run the motor pump including safety components plz explain it how we can use such components .

2 Answers  

---

What is phenomenon of electromagnetic induction and how it works?

0 Answers  

---

why we are using earth pit in sub stations.?

0 Answers  

---

Post possible questions for Power Factor Panel FAT / SAT

0 Answers  

---

Can we manually synchronize two DG sets of same ratings manually without using speed biasing ? If yes then how?

4 Answers  

---

60 watts bulb and resistor home heater is connected in series and 230v is given to the circuit. The heater is giving some amount of heat. If instant of 60 watts bulb replace 100 watts bulb what will be the output of the heater?

2 Answers   NPCIL,

---

what is the difference between electrical & electronics

245 Answers   Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS,

---

I have 10 amp MCB for my air conditioner of 1.5 ton capacity. When I connect the ac direct it is started running but when connected through stabliser the Mcb Get trip and air conditioner couldn't start.please confirm whether Mcb is required to be upgraded to 20 amp. There is no fault in ac and the stabliser. Please advice the reason of tripping the mcb when connected through the stabliser.

1 Answers  

---