How to Select a Transformer Rating ?

Question Posted / mothilal1990

3 Answers
6738 Views
Tata Steel Limited, Techno Electric and Engineering, Vedanta, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How to Select a Transformer Rating ?..

Answer / naveen

because total losses depend upon cu losses and iron losses cu losses deped on current and iron losses depend on voltage so total losses will be volt amp thats why rating in KVA

Is This Answer Correct ?

8 Yes

0 No

How to Select a Transformer Rating ?..

Answer / rajkumar

What is the requirements of the consumer according to we are fix the trasfomer rating

Is This Answer Correct ?

0 Yes

1 No

How to Select a Transformer Rating ?..

Answer / biyanka bohra

Transformer's rating is always shown in kva instead of kw because there is no phase difference between current and voltage. it is multiple of primary current and primary voltage for single phase transformer and √3*V*I for three phase transformer

Is This Answer Correct ?

0 Yes

3 No

Post New Answer

More Electrical Engineering Interview Questions

How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???

0 Answers

directional relay is typically used to respond in fault condition who it can be used just as reverse power protection which purely senes direction reversal to operate a circuit breaker?

1 Answers

Difference Between Differential Relay and Restricted Earth Fault Relay of Power Transformers

1 Answers KSEB,

Does the ELCB or RCCB trip when it is connected to a primary side of a welding transformer?

3 Answers Tata Motors,

how was the induction stove working?

3 Answers

what is the workimg of ct &pt?

5 Answers

what should be correct gas pressures to be a 1.5 ac unite

0 Answers DDK,

Why we use less dia. fuse and conductors at H.T. side, although we use higher dia. cables on L.t. side?

4 Answers RRB,

I try to check the three phase voltage in multimeter, in 125A isolator switch incommer. first i touch R phase, and then i touch Y phase using multimeter, the moment i touched, it blasts and that moment i got blindness. multimeter selector position is correct(750V AC MODE AND RED PROBE WASS IN v AND BLACK PROBE WASS IN COM. MODE. COULD ANYBODY GIVE ANSWER FOR THIS TO AVOID FURTHER ACCIDENTS PLEASE?

2 Answers

how oti and wti connections are different from each other?

0 Answers

what is the minning of propotional, integral, derivative ?

1 Answers

what will happens if one phase is missing for 33/11kv power transfomer and why?

0 Answers

For more Electrical Engineering Interview Questions Click Here