How can we calculate cable size in Low voltage & high voltage
No Answer is Posted For this Question
Be the First to Post Answer
WHAT IS MEANT BY SLIP , WHERE IT OCCUR
What is the use of oil in transformers?
what is power factor
sir plz send some previous year questions of jspl.
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
Alternator couple to diesel engine why, Alternator couple to ac service motor with gear drive for 1500 rpm possible (yes or no) aim to low input power supply give to motor then high output power taken for alternator Please answer this question
Explain Energy and Power signals?
Why the transmision line are 11,33,63,132kv?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
WHY NOT CONSIDER PROTONS IN ELECTRICITY LIKE ELECTRIC CURRENT?
working method of railway electricl loco in single wire 25000 volt
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)