what is the distance between two overhead lines
- 1 Answers
- 7469 Views
- Aurobindo, I also Faced
- E-Mail Answers
Answer Posted / 7anoter4
See:NESC National Safety Code clause 233.
See: http://www.rurdev.usda.gov/supportdocuments/uep_bulletin_1724e-200.pdf
Section 6
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
How much no load current of synchronous motor
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
defination of controlled shunt reactor
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
Why squirrel cage motor can only use with low starting loads ?
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
How can we increase fuel-power ratio of any DG set?
from which formula we select a capacitor rating?
Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.
What are linear and non-linear systems?
what parameters are should nessary for control technic dc drive(in rolling mills)?
HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com
What is current & voltage ? Voltage perform at any load without current or not?
Why Neutral Isolation is required?
