Answer / amit

lap depends on the lapping dia of the bar ..

Answer / p.sridhar

The lap length is 10 times of dia of bar and IS code no.
9417 -1989

Answer / p.sridhar

10 dia of lap welding should be done as per IS 9417 1989

Answer / guest

The lap length will be 10times the diameter of bar.

Answer / p.k priyadarshi

16xd will be lap lenth for lower dia bar,20xd for higher
dia of bar

What is the benefit of making a cantiliver proped.?

7 Answers   CCCL, Engineers India Limited,

the shearing strength of cohesionless soil depends on

2 Answers   SSC,

WHEN BRICK SIZE IS 3X5X9" , WHAT WOULD BE THE NUMBER OF BRICK REQUIREMENT FOR 100 SQFT AREA OF 5" width?

7 Answers  

what do you mean by fe500d what is 500 n what's ,d,

4 Answers  

What is the construction cost per sq foot for residential building and give bifurcation of same?

1 Answers  

how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???

0 Answers   Student,

What is the difference between opc cement to ferro cement

0 Answers  

how can change 12mmdia@150c/c bar spacing to 16mmdia

2 Answers   Apex,

How to ascertain the required grade of Steel is good for Site .....

1 Answers  

what's the formula for calculate pcc for matt(45mm aggregate)?

0 Answers   L&T,

93 sqmtrs area how many sand and how many cement is requir in 1;5 ratio

1 Answers   Godrej,

where will be the reinforcement of slab placed when there is an inverted beam and the bottom of the beam and slab are at same level ?

0 Answers