Answer / kalpesh g patel

Commissioning is the process of assuring that all systems and components of a building or industrial plant are designed, installed, tested, operated, and maintained according to the operational requirements of the owner or final client. A commissioning process may be applied not only to new projects but also to existing units and systems subject to expansion, renovation or revamping.


In practice, the commissioning process comprises the integrated application of a set of engineering techniques and procedure to check, inspect and test every operational component of the project, from individual function, such as instrument and equipment, up to complex amalgamations such as modules, subsystems and systems.


Commissioning activities, in the broader sense, are applicable to all phases of the project, from the basic and detailed design, procurement, construction and assembly, until the final handover of the unit to the owner, including sometimes an assisted operation phase.

Answer / kalpesh g patel

Commissioning is the start up of the equipment for the first time. It is when you run the equipment and carry out tests to verify it is running as intended i.e. to design specifications. Commissioning tests are normally run against a design data baseline. Commissioning also includes things like checking oil levels, fluid levels, temperatures, pressures and for general issues that are contradictory to the intended correct operation of the equipment.

State bernoulli’s application.

0 Answers  

---

If fire would be inside the plant which fire detector is to detected the fire.

0 Answers   KOC,

---

I have one problem for masoneilan displacer type LT.I give some imformation in data shéet given for liquid level range 0 to 600 mm and sg .955 problem is 0% is ok 25%(23%) or 50%(48%)and 75%(73%) and 100% is ok this is up value and down value all ok so please halpe me

2 Answers   Hyundai, TATA,

---

What is the difference between fire detector and smoke detector?

5 Answers  

---

In control valve there are two type of valve seat we can use metal to metal seat & soft seat.On this valve seat i have following doubt. 1)I have never seen practically the internal assembly of valve so my doubt is that basically weather the seat is soft seat or metal its basic MOC is same as valve body(SS or CS) only in soft seat we are using PTFE ring & place on valve seat & in metal this PTFE ring is not threr am i correct??????? 2)what are the common general rule for using metal to metal seat & soft seat,means its depend on process parameter like liquid,gas, steam & on valve leakage class.

1 Answers  

---

can someone tell me about electronic speed switch &how it conect with proximittyswitch?(with dgm)

0 Answers  

---

What is the difference between modbus,fieldbus & profibus

0 Answers   NSL,

---

what is Least Value of MICROMETER?

3 Answers  

---

Capacitance, resistance ( colour coding ), parallel & series circuits.

0 Answers   CCIE,

---

How to measure Flow of air line,what is the procedure of creating DP in line to measure Flow!

3 Answers  

---

What's the Installtion procedure of DP Transmitter for Gas,steam and water?

2 Answers  

---

䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ

0 Answers  

---