Answer / 7anoter4

The 5-10% of rated voltage represents the short-circuit
voltage that means if you connect all the secondary
terminals of the transformer together-it is a “short-
circuit”. If you supply the primary winding terminals this
short-circuit voltage you’ll get the rated current-primary
and secondary.
If the supply voltage is the rated voltage you’ll get the
short-circuit current [10-20 times the rated].

Why compensation is necessary in feedback control system?

0 Answers  

---

In case of 3 phase motor why it is called single phasing by failure of one phare unless there is rest two phase are acting. ?

3 Answers  

---

how point on wave controller works.

0 Answers  

---

Why we oil in tranformer/

5 Answers  

---

DOES AN EARTH FAULT CURRENT ON THE DELTA SIDE OF A 6.6/33KV STEP UP STAR-DELTA CONNECTED TRANSFORMER REFLECT ON THE STAR SIDE? IF YES, THEN HOW AND WHAT IS THE AMOUNT OF CURRENT REFLECTED?

1 Answers  

---

thyristor controlled APFC panel design parameter?

0 Answers  

---

What should be the protection scheme for a 15kw, 3-phase motor working in a lathe machine.

0 Answers  

---

What is the effect of pi controller on the system performance?

0 Answers  

---

In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]

0 Answers  

---

what are the factors to be considered while design the breaker either HT or LT??

0 Answers  

---

I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?

0 Answers   Siemens,

---

What is the megger value for ht

16 Answers   Electrical,

---