Answer / somesh

The question does not make sense. Is 360 the power? If so, it's unit should be mentioned clearly.

Answer / doss

I=360*1000/1.732*11000*0.8
=23A

How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.

0 Answers  

---

What is the difference between online ups and offline ups?

44 Answers   Electrical Tech, GMR, Gravity India, HCL, Indus Towers, NIT, Pyramid, Techno Electric and Engineering, UBS,

---

why are use star delta startor.

4 Answers  

---

what is the grounding Calculation formula? spouse i want to provide grounding to 3phase 18kw motor or i want to provide ground to 3phase 10kva dry type transformere or you give me any exemple...... Thanks.

0 Answers  

---

what material is the electrical housing wire made of? is there any difference for the telephone lines?

0 Answers  

---

---

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

0 Answers  

---

What is the output of below program? #include <stdio.h> int main() { int p,q; for(p=1,q=1;p<7;p++) { printf("%d%d__",p,q); } return 0; } Answers- 1. 17__27__37__47__57__67__ 2. 11__21__31__41__51__61__ 3. __11__21__31__41__51__61__ 4. Compilation error

1 Answers  

---

How to distinguish whether MCB is DC or AC looking at it physically

0 Answers  

---

whats was the problem if neutral and earth got 2volt from the ups output

1 Answers  

---

why battery is connected in series?

10 Answers   HP,

---

What is Horan Gap Fuse? Where it is used?

1 Answers  

---

why we are testing cables with DC supply not with AC supply?

9 Answers   Aurobindo, DEWA, L&T,

---