what is the difference between kg/cm2 to MMWC

Question Posted / yuvaraj

2 Answers
11640 Views
Ansaldo, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is the difference between kg/cm2 to MMWC..

Answer / santosh

Both are the unit of pressure measuring in kg/cm2 and mmwc 1ksc is equal to 10000mmwc.

Is This Answer Correct ?

33 Yes

1 No

what is the difference between kg/cm2 to MMWC..

Answer / nsunel

Yes both are measuring units of pressure . Relation is 1kg/cm2=10000mmwc. 1 atm = 10 metres wc,1atm =1kg/cm2(approx) & 1kg/cm2 =10 metres(10000mmwc)

Is This Answer Correct ?

19 Yes

2 No

Post New Answer

More Power Plant Engineering Interview Questions

DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.

0 Answers

In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?

3 Answers TATA,

63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????

2 Answers UET,

whatis means of PPA & FSA OR SFA in power plant operation

2 Answers

our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....

0 Answers SWR,

What is excitation current and voltage in hydro power plant ?

1 Answers ISS, Perfect Line,

We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?

0 Answers

why do we use contro fluid tank (cft)in turbo generator area(tg) in power plant?

1 Answers MPL,

What are the special criteria under which FD fans are switched off during MFT.

1 Answers

How We Calibrate the vaccum transmitter?

0 Answers

How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.

0 Answers Aevitas Pharmagro,

line safety is not opening but drum safety opens what to do?

3 Answers

For more Power Plant Engineering Interview Questions Click Here