Answer / rajesh.m.kon

ESD- Emergency shutdown... it is for shutdown the total plant
during or in-case of any emergency like,high pressure accured
in process , instrument air failure, or any utility failure.

PLC- programmable logic controller.. by implementing logic or
program's , we can achieve the ESD by using PLC

so ESD is a kind of logic, PLC is a hardware.

why need 3 element system in power plant? if it is not there then what l happen?

5 Answers  

---

warning lamp does not light, but it does light when the wire from the lamp going to the sending unit is grounded (the part that plugs into the sending unit) what does this indicate)?

1 Answers  

---

what is modbus?and why use it?what benifit

2 Answers  

---

I have a problem with a valve (air to close). When it is fully closed and try to open 1% it doesn't responce till 3% open suddenly more than 3% then back to 3%. I tried to tune positioner then removed it, the problem still exist. Any idea

3 Answers  

---

in the flow caluclation k value how to caluclate.mass flow & volum flow.

1 Answers  

---

what is the difference in Kg/cm2 and mmwc?

2 Answers   Niko,

---

ABB DCS (AC 800 M)redundency take howmany milliseconds to switch from master controller to slave?should be less than DCS scanning time?

2 Answers   SCS,

---

Why using negative voltage in vibration measurement?

2 Answers  

---

steam drum level transmitter calibration procedure? with example?

1 Answers  

---

I have applied the post Junior Engineer-(TM)in R.R.B CHANDIGARH recently . what type of question i have to practice and which book ?. can i get any model question paper?

3 Answers   RRB,

---

if we have 450 mm heigth boiler drum level ,so what is span & zero value for a dpt tranmitter

4 Answers  

---

What is difference between Ionization heat and bimetallic heat

0 Answers   KOC,

---