Answer / carl_ellis

Any given amount of error will produce less output change
than before the proportional band was increased.
Increasing the proportional band will make the controller
less sensitive to the deviation of the process variable
(PV) from the setpoint (SP).

Tell 'em Carl sent you.

My question may be very basic or childish but this question still persists in me, someone plz help me 1.why do we go for differential equations to analyze a system? 2.why do we solve it using matrices, is there any specific reason for using matrices other than the stories like it is simple,faster etc.

2 Answers  

---

what are the values of fuel flow rate in various places in boiler.

0 Answers  

---

Dear Sir/Madam, I am attending an interview for ETs in BHEL. I have cleared my written test under Electronics (Instrumentation). This is the first time I am appearing for an interview. Can any one who has attended the interview earlier give me a clue to face the interview. With regards Sindhu

2 Answers   Siemens,

---

SIR MAY I KNOW IF RADAR TYPE LEVEL TRANSMITTER SHOWING IN THE FIELD 0 % LEVEL AND IN DCS SHOWING 100% THEN WHAT IS THE CAUSE I CLEAN THE CHAMBER & TAKEN ONLINE BUT ONLY ONCE ITS BECOME ZERO IN DCS BUT AGAIN 100% SHOWING IN DCS,THEN I REMOVE THE POWER SUPLLY AND CONNECT IT AGAIN .IS IT OK BUT STILL IN THE DCS ITS 100% AND ON THE DISPLAY ITS INITILAZIATION PLEASE HELP ME READRING THIS?

4 Answers  

---

How can I zero check of wet leg type DP Tx ?

6 Answers   ONGC,

---

what is IEC code in cables & how to selecting cables?

0 Answers   ROS,

---

Why Boiler Drum level transmitter (TX) or level transmitter rang always put -600 to 0 other -900 to 0. Mines range why use….?

4 Answers   Uttam Sugar,

---

I have a MRE200 amplifier for controlling a mitsubishi servo motor, I would like to know how many pulses are required to rotate the servo motor by 1 degree and what must be the pulse width

1 Answers   Essar,

---

Explain bernoulli’s theorem.

0 Answers  

---

The document / drawing that is primarily used in depicting the “Bill of Materials (BOM)” of piping system is the

2 Answers  

---

What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows   very argent : my mai is merajalam143545@yahoo.com

0 Answers   Samsung,

---

please send the hpcl (instrumentation) model placement papers to my mail....

9 Answers   HPCL, Invensys, IOCL, ONGC,

---