give eg of how I/P is used in control loops

0 Answers   CEPC,

---

In dcs contol valve parameters showing like this Gain=1 or 2 , ti=7 sec, td=20sec. But temp,pressure,level control valves we are using in which type parameter side using ti,td clearly tell me

1 Answers  

---

Relation in MMWC to Flow rate

1 Answers  

---

What are the problems faced while testing HART instruments?

1 Answers   SSC,

---

How ejector(or)evactor air pump is working in thermal power plant?

0 Answers  

---

---

In closed loop control there are several “blocks” used to show the interactions between the process and the control system. These blocks are referred to as the “process” and the “controller.” Describe the relationship between these two blocks when creating a well tuned control loop.

1 Answers  

---

Absolute pressure is 700psi,what will be the gauge pressure?

1 Answers   IFFCO,

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers   OPaL,

---

sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers

2 Answers   BARC,

---

Which type of diagphram use in costic line,DM water line,natural gas line,oil line?

0 Answers   Hindustan Zinc,

---

What is the GK Value in Flowmeter?

0 Answers   IBPIL, Thermax,

---

What is basic of instrumentation

8 Answers  

---