Answer / carl_ellis

A loop folder is a manila folder or an electronic folder
that contains an assortment of documents related to the
instrumentation for a specific process control loop.

The exact contents of a loop folder are defined in a
project's standards/requirements.

A loop folder typically includes
- instrument manufacturer's spec/data sheet
- P&ID
- loop diagram
- loop check test sheet/checklist
- instrument calibration cert
- plot plan/location diagram

It can include
- loop test procedure
- hook-up diagram/instructions
- control/function narrative
- alarm setpoint list
- construction completion certificate
- interlock diagram
- flow sizing sheet
- CoC Certificate of Conformance
- COE Certificate of Origin
- MRT Material Test Report
- NACE certificate
- instrument configuration

(Compliments to Iris)

Carl Ellis
Measure First

Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .

0 Answers   Engro,

---

I have a orifice installed in plant which is design for 0~100 inH2O for 0~80MMSCFD, now due to process change the maximum flow is change to 120 MMSCFD so for this new process value what will be the DP across orifice.

1 Answers  

---

yokogawa Temperature transmitter showing Error 15 which is Reverse Cal Fail (confirmation calculation result is bad) in manual they mentioned reasion That the output goes to the value set by hardware failure mode jumper. How can solve this problem ? anybody can say solution

1 Answers   GTL,

---

The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation

0 Answers   Reliance,

---

i want know about capillary type LT transmitter installation. we can install any location in between to HP and LP leg?

2 Answers  

---

what is the use of shield cable?

2 Answers  

---

can we change the range of 3151 model level transmitter of rosemount make? present calibration range is 1000mmwc and want to change it to 2000mmwc

4 Answers  

---

Can we get the outpot in c without using getch fiction? Answer is yes but output will stay on display 4 only few second.... But can we get output without using getch and also output will hold on the display...?

1 Answers  

---

How servomotor controls throttle valve of TURBINE?

0 Answers  

---

1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?

0 Answers  

---

What s the exact height of installed transmitter?

1 Answers  

---

Can we use PLC in Hazardous Area?

2 Answers   MNHG,

---