Answer / pillay

A) high voltage side.

Answer / raman jain

Normally Tap changers are installed on HV side of the
transformers as current is less in HV side.

In response to Mr Bikas. If fault current is 52 kA then what will be the CT specification

1 Answers  

---

distribution transformer de-rating formula on over limit iron losses  

0 Answers   IESCO,

---

why constant voltage transformer should be start without load? and if started then what will happen?

0 Answers  

---

What is the minimum percentage of power that a powerplant can support in ilanding mode ?

1 Answers  

---

Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?

0 Answers   Danieli,

---

how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?

0 Answers  

---

how to find out three phase motr kw with out name plate..

2 Answers  

---

how the B-H loop obtain under the static condition

0 Answers  

---

How do you reset circuit breaker?

1 Answers   Bhel, Kaveri Steels,

---

considering the 3phase and single phase ac system the load applied and the volage given is same...will the current differs for both the cases are it wil remain same?

5 Answers  

---

what happens when one of the phases out 0f 3 phases been removed under working condition and no load condition will the machine run if so plz send me why

2 Answers  

---

How many types of losses occur in a transformer?

0 Answers  

---