Interested to Buy Any Domain ? << Click Here >> for more details...
In power transformer tappings are provided on
A high voltage side B low voltage side
C In middle of both the windings D both high
and low voltage side
- 2 Answers
- 5374 Views
- NNN, I also Faced
- E-Mail Answers
Answer Posted / raman jain
Normally Tap changers are installed on HV side of the
transformers as current is less in HV side.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
at which voltage level arcing ground is occurs ??????????
give me applications of sequence bridges . (used in 3 phase un balanced systems)
what are the differant std sizes of cable trenches?
why it is so called as xlpe(cross linked poly ethyline) cable?
Why cables and busbar both needed in LT Panels?
what happen ehen synchronisation is done at below rated speed
How PADO software increase the efficiency of power plant?
How phase to phase voltage comes 440V.
Why use the vcb at high transmission system ? Why can’t use acb?
What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1
How will polarity test of Dy5 Transformer ?
What are the types of power in electrical power?
What is the end effect of linear induction motor ??
