The slip during plugging operation is given by=
A 1-s B 2+s
C 1+s D 2-s
No Answer is Posted For this Question
Be the First to Post Answer
How the unidirectional torque produced in dc motor
calculation of lad carryinc capacity of 6mm2 cross section wire in 415 voltage circuit. What will be the amps.
how much up to LT Voltage range?
what's burden resistor, why it's used?
what is meant by trip circuit supervision & directional or non directional over current ?
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
in slip ring motor if motor specification is given how we calculate its rotor resistance in starting
what are the problems that generally occur in power flows??
a transformer runs by electro-induction principle like all motors.then why dosen't it rotate just like any other motor
How much must be gape bitween 2 cable on cable tray?
What Different of Ht Side VCB & SF6
Tell me about Simence PLC 'BLOCK'.How many types and what for.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)