Answer / debasis sahoo

During installation of Transformer on a Pole mounting structure, following checks should be made:
Ensure that the base channel of transformer is at height complying to IEC Standards:
a) Height of top of HV bushing from ground for pole mounted transformer should be 4.572 meters minimum (15 Ft)
b) Height of top of HV bushing from ground for plinth mounted transformer should be 2.75 meters minimum (8 Ft)

Ensure that base channel is horizontally leveled

Avoid jerky movement of the transformer while lifting it upwards during installation

During installation ensure that the HV bushings of the transformer are on the DO unit (or HG fuse unit) side of the structure

After installation of transformer, also check that other allied equipments such as AB switch, Horn Gap fuse units, DO Fuse sets, Lightening arrestor etc. are fitted at appropriate positions as per the applicable drawing issued by the utility.

Use PVC unarmoured cable (3 ½ core) of appropriate size and length for LV side. Ensure that the lugs are appropriately crimped at the ends.

what is the difference between ac motor and dc generator

0 Answers   ETA,

---

Give two basic sprrd control scheme of DC shunt motor.

2 Answers  

---

What is the lower limit of break-down voltage of converter transformer.

0 Answers   Tata Steel Limited,

---

what should be the motor rating for pumping water for house hold use from 60km far lake and what formula is to use please tell me

1 Answers  

---

which %age if losses increases when frequency is increased to 25%

4 Answers   Maihar Cement, Siemens,

---

what is main difference between live tank and dead tank current transformer?

2 Answers   Atul,

---

What are the uses of stepper motor?

0 Answers  

---

what is the exact direction of current? as we know current travels from higher potential to lower potential,so if we take battery +ve to -ve implies current direction is from positive terminal to negative terminal.,whereas electrons flow from negative to positive as they are attracted by positive ions.current will be the plow of charge but not flow of positive ions.please clarify my doubt friends.

2 Answers  

---

what mean ohm

1 Answers   Shoba Devlopers,

---

what is resistance?

5 Answers  

---

why HT motors are earthed only at equipment side & for it's single core cable with aluminium wire armoure using?

1 Answers   Legrand, NLC Neyveli Lignite Corporation Limited,

---

What will be the current rating of Main switch for 80 kVAR panel

1 Answers  

---