in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?

0 Answers  

---

In apron feeder how TPH is calculated?

0 Answers   Lafarge,

---

what is difference between 1/2"NPT & M20 x 1.5 cable gland?

8 Answers  

---

HOW TO CALIBRATE A PRESSURE SWITCH?

7 Answers  

---

what are the selections available in configuring a burnout protection of a controller? thanks

0 Answers   NPC Alliance Corporation,

---

plz send me general of ongc

0 Answers   ONGC,

---

what is an ambient temperature?

5 Answers   Reliance,

---

How a rtd work, and what volts/current goes to a RTD to measure the resistence?

1 Answers   DVC,

---

What is derating factor in Motor?

1 Answers  

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers   OPaL,

---

What is the difference between Pressure Safety Valve and Pressure Relieve Valve, in what condition we prefer choose Pressure Safety Valve rather than Pressure Relieve Valve? and vice versa

2 Answers   Vedanta,

---

why the steam drum and deaerator level transmitter range is in negative MMWC to zero

3 Answers   Emerson, Jindal, JKPM,

---