what is mean by kneepoint voltage? when it will happen?
( my doubt is, if CT secondary is open means ct get
saturation or blas? what are factors are required for
calculations?
plz give currect anws:
No Answer is Posted For this Question
Be the First to Post Answer
How to increase the kvah ?
Voltage drop is the:(a) Maximum potential(b) Difference in potential between two points(c) Voltage at the end of a circuit(d) Voltage produced by a source
Is there any option to replace two Genset of capacity 125KVA with one higher capacity for same office?
Why the earth terminal pin is larger than phase and neutral in three pin plug top>
why write 500v on line tester (Test pen)
How is a 100 MVA transformer cooled?
Which of the following connection is best suited for 3-ph, 4 wire system A delta-delta B star-star C delta-star D star-delta
why should the primary of transformer be connected in delta in a heat run test?
What happened when capacitor connect series in ac circuit?
How to calculate energy stored in an inductance?
a induction motar has 30-35% exciting current at no load but in transformer it is only 2-3% ofbrated current why any reason?
what you mean by frequency of an igbt& how to find it?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)