Answer / ch v kishore kumar

The line tester is withstand up to 500 volt's.
so that is the main reason to write 500 volt's.

Answer / k.prakashchandra

You can safely test up to 500 V

Answer / anuj

Thank u kishore ji.

How electrical power(MW)is varied OF an A.C Generator in response to varying steam input to a steam turbine ?

1 Answers   Hindalco,

---

wat is the importance of reactive power in power generation.....if it is zero means wat will happen to system........

22 Answers   Bhel, Jindal,

---

Find active & Reactive Power transmitted in a transmisston line having Vs30 degree(sending end) to Vr(zero degree)at receving end with line inductance X ohm. Vs(30degree)-------------------Vr(zero degree) X ohm

3 Answers  

---

how to calculate the capacitor to maintain power factor?

0 Answers   Bosch,

---

How many percent of power are not being registered if we bypass one side of the meter base terminal using #8 cu wire on 1-phase kwhr meter. 

1 Answers  

---

how to calculate the knee point voltage of current transformer?

2 Answers  

---

why ELCB can't work if N input of ELCB do not connect to ground?

5 Answers  

---

Is the force acting between two parallel conductors of infinte length carrying AC of frequency 50Hz remians constant with respect of time? If not then what would be the frequency of the force acting?

1 Answers  

---

explain safety measures in alternator?

0 Answers  

---

What is the maximum load of 240mmsequre single core cable can carry?

1 Answers  

---

xplain in detail d pr. of synchronous motors? why syn. generators r used for the production of electricity?

4 Answers  

---

If short circuit ratio is high is it bad or good for a machine then tell the reason...

0 Answers   Bhel,

---