I have made a 3 phase thyristor full bridge rectifier. But at the moment it is

I have made a 3 phase thyristor full bridge rectifier. But
at the moment it is working only for the half bridge
operation. Both the half bridges are on operation separately
but when i put it into full bridge operation the
oscilloscope output is zero. I rechecked that the pulses
are correct for each thyristor. what could be the possible
reason for this?

Question Posted / milinda4p

0 Answers
2028 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

how to select the isolation tranformer for siemens 802dsl cnotroller

0 Answers Siemens,

details of oil cell size of Breakdown voltage test of tranformer oil details as per Standardswith mushroom electrodes?

0 Answers

what is Harmonic effect?

2 Answers

Is C.T will sense the current in both direction. As i know the C.T will sense the current in only one direction.

2 Answers

what is the electrical?

0 Answers

CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor

0 Answers

If u take a kWh reading in 11 kV HT and 440 LV side at same time in yesterday today , then why LT consumed units 3-4℅ high as compared to HT units

1 Answers Brigade,

where this neutral connection goes after returning from the load(home ,factory,industries).Is it grounded at the transformer side or atthe generator side .If it is grounded then we also ground the earth connection.is there any problem with this.

1 Answers IOCL,

how many types in CT & define it ?

6 Answers

what is the ground clearance of 400KV transmission line?

9 Answers Power Grid, wbsedcl,

How isolater function when installed inelectrical 440V wiring

0 Answers

WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.

0 Answers

For more Electrical Engineering Interview Questions Click Here