Answer / naeem

Amplifier is active, while Transformer is a passive device. Amplifier's input and output impedances r independent of gain, a Transformers input and output impedances r related by the square of turn ratio.

Answer / sarmadahmed

The difference between transformer and amplifier is that transformer is passive means it doesn't produce any power, it just transfer power from one side to another while amplifier is active as it amplifies the power.

Answer / joni sharma

i think the main difference between amplifier & transformer is that a transformer transforms only voltage & current not also frequency on the other side a amplifier transforms or amplifies the frequency of sinusoidal quantity.

Answer / naveen

transformer simply transfers
the energy from one circuit
to another circuit but
amplifier not only transfers
the energy but also amplifies
the energy....
i think its the difference
between the transformer and
amplifier

Answer / puneet purohit

Ans r nice but what if we r take an example of step up transformer.in that case the voltage is increase.

why CRGO material used in transformer?

2 Answers   Honda, Yazaki,

what will happen to give a dc supply in transformers?

3 Answers  

in our 6.6kv motor feeder[it is having two sources from Bus A&B] earth fault relay is acting, we checked CBCT connection and cable meggerd values found very good still earth fault acting during first two are three start after that it will hold. please clarify what was the reason. if same motor is starting from other Bus-A it will start.

1 Answers   Gasal, Voltech,

what is the formula for 3 phase motor starting cureent deatials 3phase 148A delta 415v, efficiancy 94% can we run the motor with 200A incoming supply

2 Answers  

What is the permissible sound level for 1000kva DG set and how the sound level is calculated.

1 Answers  

we have two 11/.433 kv. distribution Transformer rating as 1000 kva & 500 kva , i wants to run parallel both transformer. both transformer impendence voltage is 5.24%, How can we run both t/f, & how sharing the load

3 Answers  

How do you select the pickup value of the relay?

0 Answers  

a transformer can have zero voltage regulation a)o pf b)1 pf c)lagg pf d)lead pf

2 Answers   SJVN,

Why we use Y-Y connection in power transformer (8-10 MVA, 132 kV to 11 KV)and D-y in distribution transformer (2 MVA, 11 KV to 440 Volts)?

4 Answers  

in india per day how much power is generated including all power station

0 Answers  

What will happen to transformer if we gave 5HZ input instead of 50/60Hz??? explain with reason

2 Answers  

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers