Answer / nikhil

To Provide the stationary Field.......

Answer / siva naik

The field wdg is placed on rotor of an synchronous machine
is exicited with dc source.when the exicitation is given to
rotor of the field wdg in its current will flow. so this
current setup an flux which expernice the torque will be
setup on rotor.acc to the farady law of electro magnetic
induction. at the same time revoluoing flux will be setup
on the aramature wdg.so that the stator aramature flux of
the mmf and stationary fileld flux will not be zero.after
certain speed the magntic locking tendcy will come to
picturei.e stator and rotor poles will be magentic inter
locking so that it will rotate with synchronous speed.

If rotor field wdg is is exicited with Ac source, in wdg
alternating flux will be setup on rotor.that the stator
aramature flux of the mmf and stationary fileld flux will
zero so that the machine does not provide any output

How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15

0 Answers  

---

What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..

0 Answers   ABB,

---

Why Indian Electricity frequency desined 50 Cycles as developed countrys are using high frequency with low voltage

1 Answers  

---

Which types of Gases occure when mineral oil burnt

1 Answers  

---

How you calculating the 30 Hp 3 phase AC motor of power what size of cable is used for this motor?

0 Answers   Dhanam Enterprises,

---

What is Ton Capacity of Air Conditioner?

1 Answers   TATA,

---

What is the difference between automatic & semi-automatic star-delta starters?

3 Answers  

---

how to cal calculate capacitance in DC Circuit

1 Answers  

---

What is TR of AC?

11 Answers   Carrier, Reliance,

---

Why dose voltage rated at 11kva

1 Answers   TK Chemical Complex,

---

temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%

0 Answers  

---

why the carbon brushes are used heat created rotating parts in eiectricity

1 Answers  

---