Answer / abhishek pandey

Most of the voltages in the power system are rated at
11kv,132kv or likewise.It is observed that these voltages
are a multiple of 11.This is because of the form factor
which is equal to 1.1 in the equation for the emf generated
by the alternator.Since the form factor is a multiple of 11
most of the voltages assume forms like 11kv,132kv or 220kv.

what is current overloading in stack

0 Answers  

---

what is the significance of per unit impedance ?

7 Answers   HP,

---

if my load is not in continuous operation so what type of panel is required APFC or fixed capacitor bank without APFC whether C.T is required in both cases compulsory? explain detail

1 Answers  

---

Can you any explain about active,reactive and apparent power in power system with example.

1 Answers  

---

Dear sir, I have completed DECE in the year 1995. I have work experience in HT and LT LINE more than five years. Now i am doing BE in EEE from rajasthan university. After completion of BE,can i apply "C" Licence sir? Please reply.

0 Answers   Balavigna,

---

in india why 50 hz and 220 volt taken as standard rating for equipments whereas in US 100hz and 110v is consided as standard rating.is this method save power.

5 Answers   Wipro,

---

what is class of SPD and dittels of all class ?

0 Answers  

---

iii) A shunt motor runs at 70 rad/sec from a 460V supply and takes in an armature current of 100A. Resistors of 2.52 ohms and 1.64 ohms are connected in series with the armature and in parallel with the armature respectively. The field excitation remains direct from the 460V supply but the generated torque is halved. Determine the new running speed. Neglect brush voltage drop. The armature resistance is 0.4 ohms. [15]

1 Answers  

---

what is the breakdown voltage value in BDV test in transformers?

6 Answers   Siva, TATA,

---

why earth hole size is biggest in socket point.

5 Answers  

---

why DC current not used in Transformer action?

17 Answers   Engineers India Limited,

---

How to calculate the rating of ELCB OR RCCB for an equipment?

2 Answers  

---