Answer / iamdon

Capacitance in DC circuit is calculated as follows.

1)From dimensinal and medium data

C=(A*e)/d
where A=cross sectional area of conductor.
e=permittivity of medium between conductors.
d=physical distance between conductors.

2)From electrical data.

C=Q/V
where Q=charge on conductor
V=potential differece between conductors.

Author:arbelectbit@yahoo.com

wat is the importance of reactive power in power generation.....if it is zero means wat will happen to system........

22 Answers   Bhel, Jindal,

---

why i can not use thimble on capacitor duty contactor

0 Answers  

---

How to calculate the phase to phase clearness of HT /// LT bus bar?????

0 Answers  

---

1) Can anyone give me a typical value for Insulation Resistance of 11kV xlpe cable? 2) How much will the IR value decrease per KM of cable length added?

1 Answers  

---

If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!

0 Answers  

---

---

Circuit diagram of tube light without starter using electrical choke

0 Answers  

---

can any one explain about when EB supply failed then how the load will transfer onto DG's step by step.

1 Answers  

---

How to assume answer to electrical questions

0 Answers  

---

What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.

0 Answers  

---

Is MV canble armour can be earthed at both ends?

2 Answers  

---

If 11 KV breaker on the primary side of a 11 KV/3.3 KV 12.5 MVA transformer can be installed at a distance of 1000 mtrs through a 11 KV cable. If no what are the probable reasons.

1 Answers  

---

different b/w counter poise and ground wire

1 Answers   L&T, TCS,

---