in which code refer the change of reinforcement dia defer to
drawing . i.e. 12mm dai into 16mm dia.
- 3 Answers
- 5223 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / jayaraj
No need of any code reference for the diameter of bar we are using.We have to match the area of steel required.
| Is This Answer Correct ? | 3 Yes | 0 No |
What is used for 1cubicmeter steel ? 1meter length square pipe how many weight ?
How do piles bear loads
Dear sir, What is the procedure for total station?How to calculate?
how many covering can be taken in the beam,column & slab also stair-case?
which things consider when the calculate the area of the flat?
why no deduction for steel is made in the volume of concrete?
An invisible line should intersect a visible line with
1 Answers PSC, PSCI, SPC Systems,
In Abutment walls (A1 side) why we are adopting fixed bearing (POT-PTFE)?
How to make tiles floor step by step procedure?
How to design staircase.plz tell me formula for the design the staircase.
How to calculate the steel for 392c.meter*450c.meter rcc slab
what is the soil bearing capacity for a 5 floor multistorey residential building and which type of soil ? what is plinth beam? in wall load calculation center to center column distance is considered or not/
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
