what will be the cement and sand needed for 1sqm plastering ? for ratio 1:6 and 10mm thick

4 Answers   HLL,

---

is it fair to recruit another prestressing agency once earlier agency has provided guide cone for post stressing the Concrete -I girders? It is observed that the bearing plate of another agency is not matching with the earlier one resulting in protruded strands after stressing from the face of girder. Kindly advice.

0 Answers  

---

calculate 1-2-4 ration concrete - cement - sand metal and water required for 1 cum

4 Answers   Gresp, L&T,

---

who to find building iron rod strenth

0 Answers  

---

proportions of m10, m15, m20, m25, m30, m40, m45, m50, m60, m70, m75, m80 etc

12 Answers   L&T,

---

one steel fixers how much ton steel fabrication he will do same how much tone he will binding?

0 Answers   PN, Simplex,

---

With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr

0 Answers   Power Plant,

---

While Calculating Quantity Of cement,sand,Metal we get cement in no of bags,Where Sand & Metal we get in Meter Cube(M3)how to convert it to Units(i.e in no of lorry's or Tractors )

2 Answers  

---

for pretensioning which will yield first and same for post tensioning?

0 Answers  

---

what is meant by shear center?????

0 Answers   DMRC,

---

How do piles bear loads

3 Answers  

---

how bitumen is prepared for NH,SH &other roads

0 Answers  

---