What is a characteristic of Store and Forward switches? A.) They forward the frame before it is completely read. B.) They work at wire speed. C.) They are the same a Cut-Through switching. D.) They read the entire frame and check CRC before forwarding. E.) They decrease latency.

1 Answers  

---

'Show cdp neighbors detail' show the following 3 pieces of information? A.) Hardware platform B.) Software version C.) Same as 'show version' command D.) Up to 1 address for each protocol E.) Non-direct connected routers

2 Answers  

---

I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?

0 Answers  

---

Of the following characteristics, which apply to UDP? Connection-oriented Connectionless Error checking Low overhead Best-effort delivery

5 Answers  

---

What are the generic parts of a network layer address? A. an intenetworks number and a URL B. a vendor code and a serial number C. a network number and a host number D. a broadcast number and a unicast number E. a domain identifier and a device identifier

1 Answers  

---

What will transport layer do when data coming from session layer. They asked about intial operation(3 - way handshake)

1 Answers   HCL,

---

Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

1 Answers  

---

Which OSI Reference Layer controls end-to-end (host to host) communication? A.) Transport B.) Physical C.) Datalink D.) Network E.) Session

1 Answers  

---

The ICMP (referred to in PFC 1700) is implemented by all TCP/IP hosts A. true B. false

1 Answers  

---

Explain the types of ospf configuration?

0 Answers  

---

What command displays the OSPF Process ID, Router ID, Address summarizations, Routing Networks, and passive interfaces configured on a router?

1 Answers  

---

Which command should you use to confound a router so that it can become a TFTP server host for a router system image that is run in a Flash? A. copy flash tftp B. config tftp server C. write, network -router name- D. tftp-server system -file name- E. setup server tftp -system name-

1 Answers  

---