Answer / guest

Answer: C

What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP

2 Answers  

---

Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'

1 Answers  

---

Which OSI layer incorporates the MAC address and the LLC? A.) Data link B.) Network C.) Physcial D.) Transport

4 Answers  

---

what is frame realay.is it a circit switching technolgy if no then what technolgy it used

2 Answers   Volvo,

---

Hi all, suppose more than two network administrators are configure same router with different configuration through telnet at the same time.. then whose(admin's) configuration will use router for routing ?

2 Answers  

---

Which of the following is an example of the Datalink Layer? A.) LLC B.) TCP C.) SQL D.) IPX E.) Token Ring F.) MAC

2 Answers  

---

Which port are used by Viruses? TCP or UDP?

8 Answers  

---

what do you mean by port triggering?

2 Answers  

---

Can you explain the difference between trusted and untrusted networks?

2 Answers   CCIE, Wipro,

---

What is the maximum request timer?

0 Answers  

---

Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecing to non-Cisco equipment C.) You must use Q.933a encapsulation if connecing to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment

1 Answers  

---

What does the 'S' mean when looking at the routing table? A.) Statically connected B.) Directly connected C.) Dynamically attached D.) Shutdown route

2 Answers  

---